An optically low signal level at a GPON or XGS-PON port initially indicates only that a problem exists—not where it is located. For targeted troubleshooting, the technician must therefore determine at which point along the fiber-optic link the abnormal attenuation or other event is occurring. Is the cause directly at the connection point, at a connector or splice—or several hundred meters away on the feeder line? Reflectometric measurement methods such as OFL (Optical Fault Locator) and OTDR (Optical Time Domain Reflectometer) are used to locate such faults.
How can a fault in an optical fiber be located?
An OTDR sends an optical pulse into the fiber optic cable and analyzes the backscattered and reflected signal components. Based on their intensity and transit time, events along the path can be detected and their distance from the measuring device determined.
Depending on the measurement, the following events, for example, can be located:
- Connectors
- Splices
- Bends
- Notable attenuation events
- Fiber ends and fiber breaks
Thus, the reflectometric measurement not only indicates that the signal level is too low but also provides a specific clue as to where along the fiber-optic link the cause should be sought.
Can I use an OTDR on on an active PON?
When measuring an active PON, the measurement must be performed in such a way that ongoing GPON or XGS-PON data traffic is not disrupted.
For such in-service measurements, a maintenance wavelength separate from the user signals can be used. 1650 nm lies outside the transmission wavelengths used for GPON and XGS-PON and can therefore be used for fault localization on an active PON.
This allows the fiber link to be examined while the PON remains in operation.
What is the difference between OFL and OTDR s in troubleshooting?
For a service technician, a complete analysis of a traditional OTDR curve is not always necessary for every fault. Often, two questions are crucial at first: What is unusual on the link? How far is this event from the measurement point?
This is where the Optical Fault Locator (OFL) comes in. It simplifies reflectometric fault location and processes detected events in such a way that the technician does not have to analyze a complex OTDR curve themselves.
A full-featured OTDR, on the other hand, offers greater measurement and analysis depth and is suitable when events on the fiber-optic link need to be examined and evaluated in greater detail.
Learn more: OFL or OTDR—which measurement method do I need for FTTH?
How does fault location work on an active PON?
The typical process can be broken down into a few steps:

Instead of checking multiple splitters, connectors, or other potential fault locations one after another, the technician receives a specific indication of the distance at which an anomaly is located on the fiber-optic link.
Which ARGUS testers are suitable for fault location?
For typical service calls, the ARGUS F200 and ARGUS F240, equipped with the Optical Fault Locator (OFL), can be used to simplify fault location.
The ARGUS F300 features a full-featured OTDR for more detailed measurements. This allows events on the fiber-optic link to be located and analyzed in greater detail.
The key benefit for troubleshooting: The observation “The optical level is too low” is transformed into much more specific information: “The anomaly is located at this distance along the fiber-optic link.”



